The previous generation of Xiaomi 3 support NFC is a major feature, but at the time it was not promoted for various reasons, and now, with Apple Apple Pay entering the country, NFC function once again attracted the industry. According to Xiaomi's official introduction, Xiaomi 5 comes standard with full-featured NFC, supporting card reading, card writing, card emulation, and P2P mode. After successfully binding the bus card, the mobile phone is your bus card, and you only need to brush the phone when you get on the bus. What's more convenient is that you can recharge your bus card at any time, without having to queue up for a long time, and you can recharge your finger. In the future, take the bus, take the subway, do not have to turn over all kinds of cards, take out Xiaomi 5 once. Now, Xiaomi officially produced a schematic diagram detailing the process of Xiaomi 5 NFC charging bus card. Let's take a look: 1, ready to work First of all, Xiaomi 5 has built-in NFC function. Our recharged bus card must also have built-in NFC chip (usually, the new card has this chip, and the old card that does not have this function can be replaced at the card replacement point). 2, open NFC Go to "Settings" - "Other Connections" - turn on NFC. 3, reading card recharge After attaching the bus card to the back of the mobile phone, after identifying the bus card, select “payment method†and “recharge amount†to enter the payment password, the payment is successful. 4, write work (especially important) The system prompts that the payment is successful. It does not mean that the bus card is successfully recharged. Next, you need to write the money into the bus card through the NFC writing function of Xiaomi 5, so don't separate the bus card from the mobile phone at this time. Otherwise, there will be a situation of recharge failure. Air Circuit Breaker,Ht Switchgear Panel,Air Circuit Breaker Machine,Ss Switchgear Bangalore Shandong Shunkai electrical equipment co., LTD. , https://www.chinasdsk.com
