What is the principle of a waterproof socket? How to install the switch socket splash box?

The socket provides us with more sockets, which provides convenience for our life or construction. For ordinary sockets, the waterproof socket is a superior invention. So, what is the principle of the waterproof socket? Why does it have the effect of splash-proof and waterproof? Some sockets in our homes, in order to be safe, how to add a splash-proof box, the effect is equivalent to the waterproof socket, then, How about the installation procedure of the splash box? Now I will introduce you to Xiaobian.

First, the principle of waterproof socket

Mainly through the sealing method, the water can not enter the part that needs protection, including the use of seals, sealants, etc., or through special design structures (such as multi-layered barriers, etc.) to make water inaccessible.

The auxiliary structure is provided with a drain hole so that the incoming water is discharged before reaching the portion requiring protection.

This content is usually achieved by setting a waterproof case.

If you are talking about a household switch socket splash box, this product can only be used as a water, protection level: IP44 is not waterproof.

If the kitchen bathroom socket is best protection level: IP66 (short-time soaking in water, violently sprayed water in all directions).

Second, the splash box installation steps

Prepare the installation tool, large screwdriver, by pressing the socket's screws.

Buy a splash box that you like and that matches the kitchen outlet.

Pull down the main power supply.

Use a screwdriver to pry the front cover of the power outlet and remove the power outlet from the kitchen.

Pull the power outlet out of the original wall slowly.

Wipe the wall clean and put the rubber gasket of the splash box onto the socket.

Slide the splash box diagonally behind the socket.

Align the screw holes of the washer with the screw holes of the splash box, and press the wall with one hand to align the screw holes in the socket box.

Align the screw holes of the socket with the screw holes of the splash box and slowly push it into the wall. Hold with one hand. Insert the screw into the screw hole of the other hand and slowly explore the experiment to see if it is aligned with the screw hole in the socket box.

After aligning, use a screwdriver to slowly screw in the screw. When the socket is close to the hole, correct the position of the rubber pad so that it is just around the splash box, tighten the screw with a screwdriver, and then screw the other side. Good. A beautiful and practical anti-fouling cover is installed.

Close the main power supply, open the protective cover, plug in the power outlet, and try to see if the circuit is unblocked. If there is no problem, we will be done.

Third, matters needing attention

1. Always disconnect the power supply before installing the splash box to prevent electric shock.

2. If the wire behind the socket is found to be overheated and peeled, it can be wrapped with an insulating tape to avoid short circuit.

Above, Xiaobian introduced the working principle of the waterproof socket, and also introduced how to buy a real waterproof socket. What indicators should I look at? I believe that everyone has a certain grasp of the identification of waterproof sockets. Xiao Bian also detailed the installation procedure of the splash box. After the splash box is installed, it can also protect the socket from water splashing, but the effect of the two is different. One starts from the material and the other is physically. Isolating the splash of water, both of which are good ways to prevent the socket from entering the water.